Eiki LC-XS25 Manuel d'utilisateur télécharger pdf (Page 61)

Follow these steps to replace the lamp.

Turn off the projector and disconnect the AC power

cord. Allow the projector to cool for at least 45

minutes.

Loosen 2 screws of the lamp with a screwdriver and

pull out the lamp upwards vertically by grasping the

handle.

Replace the lamp with a new one and tighten the 2

screws back into position. Make sure that the lamp is

set properly. Replace the lamp cover and tighten the

screw.

Loosen the screw with a screwdriver, slide and open

the lamp cover.

Connect the AC power cord to the projector and turn

on the projector.

Reset the lamp replacement counter.

See "Resetting the Lamp Counter" on the next page .

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give

the following information to the dealer.

● Model No. of your projector : LC-XS25/LC-XS30

● Replacement Lamp Type No. : POA-LMP127

(Service Parts No. 610 339 8600)

Lamp

Handle

Screw

Lamp Cover

Maintenance and Care

Screw

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 79 80

Pas de commentaire

Eiki LC-XS25 Manuel d'utilisateur Page 61