Eiki LC-XS25 Manuel d'utilisateur télécharger pdf (Page 17)

To the AC outlet.

(200 - 240 V AC)

Installation

This projector uses nominal input voltages of 100-120 V

or 200-240 V AC. This projector automatically selects

the correct input voltage. It is designed to work with

single-phase power systems having a grounded neutral

conductor. To reduce the risk of electrical shock, do not

plug into any other type of power system.

Consult your authorized dealer or service station if you are

not sure of the type of power being supplied.

Connect the projector with all peripheral equipment before

turning the projector on. (See pages 14-16 for connection.)

Connecting the AC Power Cord

NOTE ON THE POWER CORD

AC power cord must meet requirement of the country where you use the projector.

Confirm the AC plug type with the chart below and proper AC power cord must be used.

If supplied AC power cord does not match your AC outlet, contact your sales dealer.

To power cord

connector on your

projector.

Projector side

AC outlet side

Ground

To the AC outlet.

(120 V AC)

For the U.S.A. and Canada

To the AC outlet.

(200 - 240 V AC)

CAUTION

The AC outlet must be near this equipment and must be easily

accessible.

For the U.K.For Continental Europe

 Note:

Unplug the AC power cord when the projector is not in use.

When this projector is connected to an outlet with the AC

power cord, it is in Stand-by mode and consumes a little

electric power.

Connect the AC power cord

(supplied) to the projector.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Pas de commentaire

Eiki LC-XS25 Manuel d'utilisateur Page 17