Eiki EIP-1000T Manuel d'utilisateur télécharger pdf (Page 54)

Removing and Installing the

Lamp Unit

• Make sure that you remove the lamp unit by

the handle. Do not touch the glass surface of

the lamp unit or the inside of the projector.

• To avoid injury to yourself and damage to the

lamp, be sure to carefully follow the steps

below.

• Do not loosen other screws except for the

lamp unit cover and lamp unit.

Press oSTANDBY-ON on the pro-

jector or eSTANDBY on the re-

mote control to put the projector

into standby mode.

• Wait until the cooling fan stops.

Warning!

• Do not remove the lamp unit from the projec-

tor right after use. The lamp and parts around

the lamp will be very hot and may cause burns

or injury.

Disconnect the power cord.

• Unplug the power cord from the AC

socket.

• Leave the lamp until it has fully cooled

down (about 1 hour).

Remove the lamp unit cover.

• Turn the projector over. Loosen the user

service screw (1) that secures the lamp

unit cover. Remove the lamp unit cover

(2).

Lamp unit

AH-11201

Info

Optional

accessory

AC socket

User service screw

(for lamp unit cover)

STANDBY-ON button

EIP-1000T_EN_l 05.7.13, 0:02 PM51

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 63 64

Pas de commentaire

Eiki EIP-1000T Manuel d'utilisateur Page 54