Eiki LC-XB22 Manuel du propriétaire télécharger pdf (Page 12)

Part Names and Functions

This remote control emits a laser beam from the laser light window. With the LASER button pressed, laser light goes on.

The signal emission indicator lights red and laser is emitted with red light. With the LASER button pressed for more than 1

minute or released, the light goes off.

To lock this function, press both the MENU button and the NO SHOW button for more than 10 seconds. To unlock, press

the MENU button and NO SHOW button again for more than 10 seconds.

The laser emitted is a class II laser. Do not look into the laser light window or shine the laser beam on yourself or other

people. The caution labels for laser beam are shown below.

CAUTION : Use of controls, adjustments or performance of procedures other than those specified herein may result in

hazardous radiation exposure. Do not look into the laser light window while laser is emitted, otherwise eye

damage may result.

Laser Light Window

The caution label is put on the remote control.

Signal Emission Indicator

To insure safe operation, please observe the following precautions :

● Use (2) AAA, SUM-4 or LR3 type alkaline batteries.

● Replace two batteries at the same time.

● Do not use a new battery with a used battery.

● Avoid contact with water or liquid.

● Do not expose the remote control to moisture, or heat.

● Do not drop the remote control.

● If battery solution has leaked in the battery compartment, carefully wipe the compartment clean and install

new batteries.

● Risk of explosion if the battery is replaced by an incorrect type.

● Dispose of used batteries according to the instructions.

Press the lid downward

and slide it.

Remove the battery

compartment lid.

Slide the batteries into

the compartment.

Replace the compartment

lid.

Two AAA size batteries

For correct polarity (+ and

–), be sure battery

terminals are in contact

with pins in compartment.

12 3

Point the remote control toward the projector (Infrared

Remote Receiver) whenever pressing any button. Maximum

operating range for the remote control is about 16.4’ (5m)

and 60° in front of the projector.

60°

Operating Range

16.4’

(5 m)

Remote control

Remote Control Battery Installation

Laser Pointer Function

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Eiki LC-XB22 Manuel du propriétaire Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs Eiki LC-XB22